Bipump 1224 Fuel Transfer Pump With Hose / Nozzle Kit.
The Bipump is a rotary vane self-priming pump that can be operated on either 12 or 24 volts D.C. and has a large flow rate. It is fitted with a bypass valve, has a cast iron pump body, a steel shaft, which is fitted with a lip seal, and has a TESV IP55 motor fitted with crocodile clips and a line fuse. It has a duty cycle of 30 minutes. A useful carrying handle is fitted and it is mounted on a base plate. Maximum suction lift, with a foot valve, is 5 metres, however without one, 3 metres, or less, is recommended.
It can be supplied as a bare pump or with a pumping kit, that comprises a manual nozzle*, hose fittings, strainer and 5 metres of rubber/PVC hose that can be cut to required suction and discharge length. Maximum liquid temperature is 50ºC. It should not be run dry, so an initial priming of diesel is necessary. Suitable for biodiesel. It MUST NOT pump water, petrol, high viscosity liquids, chemicals, solvents or products with a low flash point.
* Some cars will not accept this size of nozzle (please check with our sales
department for guidance)
Flow rate up to 85Ltr/min and max head up to 12.5 metres.
Motor 12v or 24vDC 35-18amps.
Port Size 25mm.
Please click here for a technical data sheet.
